Brunswick VCE Slope 2002

Slope is a measurement of the incline, or the steepness, of a surface. Slope was derived from the TIN (see description under DTM on page 6 of the supplemental METADATA file). Slope was generated as a percent slope (which is the rise divided by the run multiplied by 100). The illustration to the right shows slope classifications and hydro (left side) and slope classifications with aerial photography and hydro. Slope layers are often used in site suitability analysis to support economic development, community planning or zoning, agricultural suitability analysis, precision agriculture, natural resource management, and water retention and surface water runoff modeling. The Virginia Geospatial Extension Program developed the slope layer using the TIN. It is suitable for general (regional) planning purposes and should be verified. Format: Shapefile Attribution: (Refer to Table in supplemental METADATA file under Slope.) Projection Information: -NAD 1983 -State Plane Virginia North or South (Contingent on locality, refer to index map in the Appendix) -Linear Unit: US Foot Source: Virginia Geospatial Extension Program This data has been curated by the Virginia Cooperative Extension at Virginia Tech and Virginia Tech University Libraries. This data is meant for general use only. Virginia Tech's University Library is acting as a steward for this data and any questions about its use should refer to our Terms of Use Page.
Brunswick County, Virginia
Held by:
Virginia Tech University Library